|OpenWRT WAG354G V2 AnnexA problem
|Page 1 of 1|
|Author:||latteye [ 22 May 2008, 09:48 ]|
|Post subject:||OpenWRT WAG354G V2 AnnexA problem|
I have tried OpenWRT WAG354G V2 AnnexA in http://www.webalice.it/markvd/openwrt/
That can't boot in my route.
I don't have jtag, so I don't know what happend during the boot.
|Author:||Jacek [ 02 Jun 2008, 23:23 ]|
|Post subject:||Re: OpenWRT WAG354G V2 AnnexA problem|
My router (V2 AnnexA) boots up, however I can't log to it
Power led is 'craaaasy' - I have the same behavior on (V1 AnnexA) and I can logon.
Any idea ?
(@latteye - you have to wait 2-3 minuts after flashing - don't turn off switch if 'power led' blinking)
I found source of the problem: acx111 driver (tested with v0.3.36 and 37) .
acx: this driver is still EXPERIMENTAL
acx: reading README file and/or Craig's HOWTO ....
acx: compiled to use 32bit I/O access.....
acx: running on a little-endian CPU
acx: PCI/VLYNQ module v0.3.37 initialized, waiting for cards to probe...
<-- and router hangs
If you don't need wifi you can use fresh build from: http://downloads.x-wrt.org/xwrt/kamikaz ... s/ar7-2.6/
|Page 1 of 1||All times are UTC + 1 hour [ DST ]|
|Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group